 |
| Scuttle back on. Dash an trim trial fitted |
Work then came to a halt as I couldn't find the required "peel" rivets to attach the side trim panels. Should look good when its done though..... provided the seats will still move when they go back in.
November 11th 2012 - Scuttle back on
After the simple task of shortening the heater input/output pipes and making two holes for them to connect through to the engine bay, the scuttle assembly was finished. Now a lot heavier than it was, it went back on without fouling anything. Its now quite busy under there, but seems to fit together well.
The manual says the optional side trim panels should be fitted before the scuttle is secured, so out came the seats and the panels went in after cutting out the holes for the seatbelt anchors. At this point I trial fitted the dash and the pad on top of the side to see how they will fit together.
Work then came to a halt as I couldn't find the required "peel" rivets to attach the side trim panels. Should look good when its done though..... provided the seats will still move when they go back in.
Work then came to a halt as I couldn't find the required "peel" rivets to attach the side trim panels. Should look good when its done though..... provided the seats will still move when they go back in.
Subscribe to:
Post Comments (Atom)
No comments:
Post a Comment